We recommend applying at least one coat of your chosen coating before installation. This can initially raise the grain which would then require a light sand. When fixing using panel pins, this first coat will also help when filler is applied into the panel pin holes, creating a barrier for the filler to sit on. When lining ceiling or hard to access areas, the more coats that can be applied before installation, the better. Once installed the final coat can be applied.If used as a soffit or porch lining LOSP H3.1 treated panels are recommended. Check compatibility with the coating and ensure the coating is suitable for exterior applications. Do not use smooth faced plywood in exposed exterior environments.
NZ Decorative Plywood achieves Group 3. To gain higher performance rating contact Zone Architectural 09 623 1699 info@zone.net.nz
Negative details can create clean, sharp lines giving a great aesthetic and allow room for panel expansion or movement.
When using a negative detail we recommend a small aris on the plywood edges, just enough to take the sharp edge off. This can also be achieved with a soft sand.
Options to darken negative details include black tape, paint or foam for larger negative details.
There are many fixing methods, the most common for non structural are:
• Direct Fixing: Pins and Glue (40 x 2.0 panel pins or No 8 gauge screws)
• Concealed Fixing: Adhesives only
• Concealed Fixing: Clip/Plug systems - Fast Mount
Pre Installation Inspection:
• Prior to installation inspect panels for visual defects. Responsibility lies with the installer to ensure panels meet the aesthetic requirements of the project
• It is not possible to guarantee an absolute consistency in colour of plywood between sheets. A slight variation between sheets cannot be considered a defect. Check sheets before commencing your project
• Stand up your panels, plan which sheets will hang side by side to limit and control the variation between sheets
• If lining several areas, sort sheets for the different spaces to limit and control the variation between sheets
• Ensure selected face veneers face up when stacked to ensure panels are fixed the right way
• For best results install panels in as close to the final internal environmental conditions as possible
• Store panels in a dry, cool area.
• When laying out allow for expansion gaps and trimming of all panel edges
IPL manufactured Decorative and Structural plywood carries a 12 month warranty against faulty materials or workmanship by the manufacturer to the extent of replacement of the product but not including any indirect or consequential loss subject to the provisions of the Consumer Guarantees Act 1993.This warranty applies only where the product has been used in accordance with the recommendations. Any defect must be advised to the manufacturer within 21 days of determination or from the day such defect should have become known.
.png){kind=logo}
.svg){kind=logo}
